Recherche

e. 6.3 ml. A separator may be used when the amount of available sample is low (6 ml required). It can also be provided with inserts producing a flat sample (1 or 2 mm thicknesses). These inserts are made

used. Sample temperature in °C. Pressure in the furnace vessel in mbar. Temperature setpoint that can be entered manually with Up/Down keys. Bar graphs indicating the output power (OP) and the temperature

loop are off. (svg - 144 Ki) Use of the 2704 controller You can enter the setpoint with the computer of the instrument. The heating setpoint can also be directly and manually increased or decreased by using ... vanadium thermal shields. Replace the sphere and the shields and start the vacuum pump. The vacuum drop can take some time - it depends on ...

been made to the instrument. These measurements are mandatory. The conditions in which a cryomagnet can be used are determined from these measurements and reported in the Safety section. The vertical force ... the magnitude of the horizontal force and its orientation relative to the sensor #1. A high alarm can be set to indicate when stopping the ...

protocol from Igor 's command line or from an Igor procedure. A full description of the Modbus protocol can be found at http://www.modbus.org . This XOP is based upon the FieldTalk™ Modbus Master C++ Library ... thing is that you know what your instrument expects and what the Modbus operations do so that you can coordinate them. This plug-in is ...

Institut Laue Langevin. This XOP is based upon the omniORB library: http://omniorb.sourceforge.net/ . It can be used with any other instrument control software able to run a CORBA client. This version requires ... service and enter the CORBA command in Igor with the IP address of the omniNames server. The client can then be used to test the ...

cryomagnet, even when the detector is placed at the worse position of 60°. In conclusion, this magnet can be used up to the maximum field when the goniometer is dismounted. 158OXHV26 (15T) Stray Magnetic Field ... factor 5 but the horizontal force is multiplied by 2 at the same take-off. Below 105.7°, the magnet can be used up to the maximum field ...

40 and 270 daN at the maximum field of 15 T at the two take-off angles 42 and 90°. The cryomagnet can therefore be used up to nominal field. Previously, the applied field was limited to 9T at a take-off

goniometer with the old goniometer, the vertical component of the force is divided by a factor 5.5 and we can see the low horizontal force of a few daN. The use of this 17T magnet is therefore permitted up to

No additional magnetizable or magnetic items are authorized between magnet and monochromator. D23 can use the 12T and 15T magnets up to nominal field, provided the distance of 855 mm is kept between the