Recherche

This means that the over all beam polarisation depends on the subsequent collimation where divergence can vary from ~0.10° @ Col = 17.6 m to ~1.2° @ Col = 1.4 m. A further effect to consider is possible d ... collimation barrel. This means the guide field remains constant while either collimator or guide sections can be rotated to make the desired ...

supply, and the detector is not grounded anymore (can charge again). A short delay later, during 6 seconds, relay 1 is closed, so that the detector can charge up rapidly. After these 6 seconds, relay 1 ... commands. We can also plug the "discharge" cable into the 6 V supply. Finally, we might need to plug it into the small tool (from topic 13.2.5) ...

goniometer with the old goniometer, the vertical component of the force is divided by a factor 5.5 and we can see the low horizontal force of a few daN. The use of this 17T magnet is therefore permitted up to

the visitor zone /home/vis/d22/your_name in which you can work. The treatment of SANS data is explained in detail on the ILL web pages, where you can also find information on raw data and treated data formats ... been added. Printer queues on d22sgi Available printers can be seen by choosing Printer Monitor in the Toolchest under System. These ...

case of a single run, READY remains low until a new series is started by MAD. The whole procedure can be repeated n times using the repeat item in the KIN command. Web document produced by Roland May,

momentum transfer Q the corresponding values of the maximal and minimal dimensions in the sample that can be resolved with this setting. Complete the setting information by choosing the collimation, the beamstop ... By if they have not been determined, and to leave the detector angle at 0. Once all this done, you can use the "Send" command to ...

available buttons corresponding to this sample rack is then read from the instrument parameters. You can enter a different number of positions manually. After that, choose the "sample table" button. This ... should fill in the sample names according to their positions. You don't need to fill all lines. You can jump from field to field using the tab ...

actinide samples are exposed to neutrons. This can lead to the production of fast neutrons (as a function of the respective fission cross sections) which can create a significant background on the neighboring ... sample position the remaining background can still cause problems. In particular variations of this background (opening and/or closing of ...

file macro for GEORGE The GEORGE dial (macro) can be started from the "setup" menu in the D22 GEORGE pad ("Kinetics files"). The progress of the measurements can be followed graphically by the application ... using the corresponding item from the acquisition menu in the D22 GEORGE pad. Real-time measurements can now use multiple MAD KIN files ...

controller (GE Fanuc). Its function is visualised on a page of the supervision program InTouch. This page can be accessed by a button on the InTouch main menu page. Normally, this page is in a pure status mode